User Guide

9
Figure 19
Figure 20
Figure 21
27. Before attaching the drop pockets to the rails you will need to
trim two of them to fit into the side pockets. (See figure 21)
Insert the corner and side drop pockets (the two that you have
trimmed) into the drop pocket openings on the table. THE LIP
ON THE POCKETS GO INTO THE RECESSED AREA ALONG
THE INSIDE RIM OF THE CORNER AND SIDE CAPS. Front edges
of pockets should fit snugly against the playfield cloth on the
inside of the openings. Trim drop pockets if necessary to assure
a snug fit.
28. Fasten drop pockets to rails using three nails #17 per pocket.
Hold the nails with needle nose pliers and tap them into plastic
with a small hammer. Place nails about ½ inch below the top of
the pocket (so the balls will not be able to hit the nails and
become chipped). Once nails have started into plastic, hammer
them completely into the rails until heads are flush with plastic.
(See Figure 19)
29. Place playfield spots #23 on table as shown in figure 20.