Service manual
B
ACDEFGSERVICE
21
D6 Installation the restrictor plate (Vertical Power Flue Only)
Every Vertical Power Flue must have the restrictor plate tted when installating a DL850
or DL1100. To do this:
□ Remove the powerue lid, remove the screw that secures the elbow & then slide the
elbow o.
□ Attach the restrictor centrally over the air
inlet as shown using the two rivets provided.
□ Replace the elbow, replace the screw, and
then replace and secure the lid.
D7 Running the Flue
Run the Ø100mm and Ø75mm exible aluminium hoses from the cavity to the rear of
where the Horizontal or Vertical Powerue Terminal will be installed. The ue system for
the DL850 / DL1100 is zero rated, so no spaces are required between the ue and
any timber framing. Allow enough stretch in the exible aluminium ue to allow it to be
able to protrude through the wall/ceiling to enable it to be connected to the Powerue
Terminal. The ue should be expanded at each end in order for the ue to be attached to
the re / powerue.
For information on running the PolyPro ue , see the installation manual which is supplied
with the ue components.
It is advisable to secure the exi ue at regular intervals to prevent vibration and move-
ment. Steel wire or ‘builders strapping’ may be used for this purpose.
Note: The exible ue is shipped in a ‘compressed’ form. Extend it to your desired length by
stretching (up to 4m maximum per length).
D8 Running the Powerue Electrical Cable
Note: The Horizontal Powerue Wall Terminal is powered from the appliance, and must be
connected to the appliance with the supplied electrical cable only.
Run the electrical cable from the cavity where the appliance will be installed to the hole
in the outside wall. Ensure it is not draped over, or in contact with, the outer shell of the
appliance or the ues and kept clear from any other possible heat sources, sharp edges,
or moisture. Fix it appropriately and allow enough cable looped to be able to pull both
the appliance and the Horizontal Powerue Wall Terminal out from their installed posi-
tions.
END OF SECTION D
By the end of this section, you should have:
□ A weather-tight installed Horizontal Powerue Wall Terminal with clearance as
specied by AS/NZ5601
□ Reasonable access to the outside face for maintenance purposes
□ Flue attached to the rear of the Horizontal Powerue Wall Terminal leading back to
the appliance
□ The electrical cable from the Horizontal Powerue Wall Terminal attached to the
rear of the installation and run back to the appliance cavity in an electrically safe manner