Service manual
B
A C D E F G SERVICE
22
E
Installing the Appliance
E1 Installation
Note: Ensure the wall has been lined and nished (plastered/painted/covered) before
starting the appliance install. Plug the powerue electrical cable into the appliance in the
back right hand side.
With the appliance electrical cord plugged into the outlet in the cavity, carefully place
the appliance on the cavity base and push it into the cavity. Bring the gas connection
through the outer shell of the appliance and connect it to the regulator on the bottom
right hand side of the appliance. The gas pipe should have already been tested as per
section C.
Gas pipe entry positions
Regulator
Inlet gas connection
(Grommet)
(Plug)
Installer to swap plug and
grommet if required
Note: If using rear entry for gas pipe (shown above), re-use the plug from the side entry posi-
tion.
Note: The regulator that is supplied with the re MUST NOT BE REMOVED. Removal of the
regulator, or replacing it with one not intended for use with an Escea re, will void the limited
appliance warranty.
E2 Connecting the Network Cable
If a network cable is being installed for a wired
connection to an internet router/network (as per
Section C2) then bring the cable through the
chassis as described earlier and attach it to the
correct socket inside the electronic tray.
Remove the electronic tray by unscrewing the
two screws at the front and pulling the tray for-
ward and over the lip in the front of the chassis.
Unscrew the four screws in the top and remove
the lid. Bring the network cable through the side of the tray and plug it into the net-
work socket. Replace the lid and electronic tray by reversing the steps above. Ensure the
network cable does not interfere with the pressure switch hoses beneath the rebox and
does not rest against the rebox bottom surface.