Service manual

A C D E F G SERVICE

Step 9: Push the supplied magnet brackets

into position. Place the bottom fascia trim

onto the magnets. If this panel does not t,

adjust the outer fascia side to side or the ap-

pliance in/out until the trim ts well.

F3 Fitting the Quadrato or Quadrato Lite Fascia Panels

Step 1: Ensure the glass and all glass retainers are securely tted

Note: If the glass gasket requires a replacement, call your nearest Escea agent who will

ensure the part is replaced with the correct type. In the event that the glass is broken by

impact, purchase the replacement from an authorised Escea agent only.

Step 2: Attach the Outer Fascia Bracket to the top lid as shown below

Step 3: Screw the two Outer Fascia studs into the two brackets at the bottom left and

right of the appliance as shown below.

Step 4: Attach the two inner fascia brackets as shown:

Step 5: Hang the Inner Fascia from the metal bracket on the front of the rebox.