Service manual

A C D E F G SERVICE

S7 Replacing Electronic Drawer

ISOLATE THE POWER TO THE FIRE

BEFORE THIS PROCEDURE.

All of the electronic components

of the heater have been located on

a removable drawer. This drawer is

located under the rebox,

near the front left of the

appliance. On the back of

the drawer are two large

connectors that unplug as

the drawer is removed.

Remove the protective

grill from infront of the

electrical connections

(shown in rst diagram)

and unplug electrode wire

from rebox and remove

screw holding earth strap

to rebox. Take out the

two screws at each end of

the electronic drawer and

pull drawer outwards and

up slightly to clear the

chassis lip. If an ethernet /

network cable is con-

nected the lid of the drawer will have to be removed and the cable unplugged before the

drawer is completely extracted from the re.

Reverse this procedure to ret. Ensure drawer is fully seated into the draw housing.

S8 Replacing a Wireless Control:

If the wireless control becomes lost or damaged, a new one can be

ordered from any Escea retail agent. When you have the new remote,

the following procedure needs to be followed to “teach” the remote

to only communicate with that re.

1. Ensure the re and remote are set to “O” (only the time is dis-

played on the remote).

2. While the remote is in its “OFF” mode with only the time showing

on the display, press the MINUS (4), PLUS (8) and FAN BOOST (7) but-

tons simultaneously (as shown right) until the characters “03” light

up on the display. Release the buttons and the remote will count

down and display “GO”. The screen will then display all characters.

This will put the remote into test mode and the two big temperature

digits should begin counting from 0 to 99 repeatedly.

Spark Electrode

Earth Strap

SETTIME