User guide
Combustion Air
Flow Error
• Check whether the pressure switch is activating at startup (there is an
orange indicator LED in the control tray). If not check the pressure switch
electrical connection is correct.
• Check that the hoses are connected at both ends. Ensure the hoses are not
kinked.
• Ensure the pressure switch is mounted vertically and the diaphragm is op-
erational. The grey hose should be connect to the low pressure port and the
translucent to the high pressure port
• Check that both ues are securely connected at both ends to the appliance
and the powerue wall terminal and that the ue is not damaged
(DX Only) Duct
Overtemp
The hot air duct temperature sensor has detected excessive heat at the duct
outlet.
• Ensure that there are at least TWO air vents installed and open in the same
room as the replace
• Ensure the duct fan is operating when the replace is running. If not check
that the duct fan cord is plugged into the replace.
11. Power Failure
In the event of power failure the re will immediately shutdown and the gas valves will automatically
close. If the remote was turned o after the power cut then the re will return to standby mode once the
electrical supply is restored until its next use. If however the remote was left in the on mode then the re
will relight within a few minutes of the electrical supply being restored.
12. Warranty
1 This document sets out the express warranties that apply in respect of Escea products purchased in
either:
(a) Australia with the exception of Western Australia, provided by Glen Dimplex Australia Pty Limited
ABN 69 118 275 460 of Unit 2, 205 Abbotts Road, Dandenong, Victoria 3175 (Phone number 1300
556 816) (we, us our).
(b) Western Australia, provided by Airgroup Australia of 28 Division Street, Welshpool, Perth, WA 6106
(Phone number 893 502 200) (we, us our).
(c) New Zealand, provided by Escea
The express warranties in this document apply to the particular Escea product which this warranty
has been included in the packaging for or otherwise supplied with (the Escea product).
2 Escea express warranty
Subject to the exclusions in section 3, we warrant under this express warranty that the below parts
of the Escea product will be free from defects of materials or workmanship for the periods specied
below (with each of the below periods commencing on the date the Escea product was purchased
by you as a brand new product from a retailer located in the regions outlined in section 1):