Instruction Manual

Page 4

Rev1.0 EN

Using the Eclipse Scholar

1. Setting up

Lift the Eclipse from its packaging and

place it on a solid, level desk. Raise the

screen upright.

Plug the power adapter into the mains

using the lead provided and insert the

other connector into the socket on the

rear bulkhead of the Eclipse.

Ensure the unit is placed at least 10cms

(4 inches) back from the edge of the

desk. Sit in front of the unit.

Press the red button on the right of the

front panel to turn the Eclipse on. The

Eclipse will beep to indicate power-on

and the lamps will light. After a few seconds, the image will appear on

the screen.

Release the brake on the

reading table and pull the table

out towards you. If you push

the table back in again, you will

see that the table locks home

only when located centrally

between its legs. Place some

text on the table and you should

see it on the screen.

The distance camera is discussed in a later section of this manual.

2. Folding down and moving

Turn off the unit and unplug the power adapter from the Eclipse and

also from the wall socket. Disconnect the distance camera cable and

Min 10cm / 4 inches

Lock

Unlock

Lock