Product Manual
miniLIFT - Mobile Lift System - MODEL #92050
5
1.800.352.9852 • info@esco.net •www.esco.net
PACKAGING AND TRANSPORT
All parts of the miniLIFT will be sent on a single pallet:
The movement and transport of packaging must be done according to safety standards and with experienced
staff in the transport of mechanical load. Staff should wear appropriate protective clothing. DO NOT manually
transport the package containing the lift. Inside the packaging all parts are presented separately.
INSTALLATION AND CONNECTIONS
The miniLIFT is a mobile lift, and has to be used on a smooth and level oor, protected from damaging factors such
as temperature and humidity. The perfectly level oor must be able to withstand the weight of the vehicle and lift.
It should not be used on a rough surface or any type that does not full the minimum requirements for the proper
functioning of the lift.
WARNING: The described operations have to be performed by expert and responsible staff. Before starting the
installation, a clean area has to be dened free of any obstacle.
If using a crane, you are required to comply with the safety standards. Do not touch, or stand within or under the
radius of the crane.
If using a crane to carry the lift.
• Lay the package at and use two straps attached to the crane to transport the lift correctly.
• Pay attention that the straps are properly located at either end of the package.
• Lower the lift to required position on the ground.
(Necessary security it is recommended to dene a space at a certain distance of another object or wall in the
location where you will use the lift.)
When opening the packaging, check that all the components are present. The check
is to be done in the presence of the carrier, to see if a component is lost. ESCO is not
responsible for any damage due to transportation, loading, unloading and unpacking.
Diagram shows
installation of the operation han-
dle. Make sure to tighten screws
completely to ensure handle
does not come off the unit.