Owner's Manual

Operation
Operation
19 20
Press SEN to go from
one category to the next your setting within a category
Press VOLUME + or – to change
Serial Number and Software Version
To view your MAXcam 360c’s serial number and software revision, press and hold the MRK and MUTE
buttons while powering on the detector.
User Mode
Advanced Access and customize all settings and preferences.
Novice Access and customize only Units (English or metric) and Display Color. All other
preferences are set to factory defaults. To view all settings and preferences, you
must switch to Advanced mode.
Arrow Mode
Single Arrows are displayed indicating the direction of only the primary threat. All arrows use
your selected display color.
Multiple Threat-direction arrows are displayed for multiple threats. When multiple threats are
displayed, the direction arrow of the primary threat will blink.
Band Threat-direction arrows are color-coded for the band that is being detected. When
multiple threats are displayed, the direction arrow of the primary threat will blink.
X band = green, K band = blue, Ka band and Laser = red
Display Color
The display graphics can be changed to blue, green, red or orange to match the instrument lighting of
your vehicle.
Speed Display
Turns Speed Display off or on. When Speed Display is off, the vehicle’s voltage is displayed.
Cruise Alert
While traveling below the set Cruise Alert speed, all alerts sound a short double beep. The alert will fully
sound when you exceed the Cruise Alert speed.
Over Speed
You can set the Over Speed alert to notify you when you are traveling over a specified speed. When you
travel above the speed that you have set, the background display for your current speed will turn red and
a voice prompt will announce “Over Speed”.
When connected to the Drive Smarter app or a mobile Wi-Fi hotspot, the Over Speed setting is
automatically set to the speed limit showing on the display. If no speed limit data is available and the
display shows --, the Over Speed setting is used.
Over Speed Limit
Note: this setting only applies when MAXcam 360c is connected to a Wi-Fi hotspot with internet
connectivity.
When the speed limit is exceeded by the set speed, the background for your current speed will change
to red and a voice prompt will announce “Over Speed”. If no speed limit data is available and the display
shows --, the Over Speed setting is used.
Meter Mode
MAXcam 360c offers five different settings for displaying information about alerts.
Standard
The Standard meter mode provides only the band information and front signal strength information of a single
alert. When radar is detected, the band (X, K or Ka) and a bar graph of the signal’s strength are displayed.
When laser is detected, the display will simply read “Laser.” If there are multiple alerts present, only the highest
priority threat is displayed. Laser is the highest priority threat, followed by Ka, K, then X band radar.
Standard FR
The Standard FR meter mode displays the band of the highest priority threat along with a front and rear
bar graph of its signal strength.. The left bar graph shows the signal strength in front of the detector while
the right bar graph shows the signal strength from the rear. If there are multiple alerts present, only the
signal strength of the highest priority threat is displayed. Laser is the highest priority threat, followed by
Ka, K, then X band radar. The number in between the bar graphs is the total number of alerts that are
being detected.