Owner's Manual

InstallationInstallation

7 8

Your new detector comes with our latest EZ Mag Mount™. Simply slide the detector onto the

mounting bracket fully and that’s it. To remove the detector from the mount, simply pull the

detector off of the mount.

Mounting Tips:

• Center of windshield between driver and passenger.

• Ensure clear view of road ahead and sky above.

• Avoid windshield wipers and heavily tinted areas.

To mount the detector in your vehicle:

1 Remove backing from EZ Mag Mount.

2 Firmly press the EZ Mag Mount onto the windshield and ﬂip the locking clamp to secure.

3 Tilt the display end of the detector slightly upward and engage with the mounting bracket.

The EZ Mag Mount magnet holds the detector ﬁrmly in place.

4 To adjust view, loosen thumb wheel and adjust angle of mounting bracket. Tighten thumb

wheel to secure.

5 To remove the detector, simply lift the display end of the detector upward. The detector will

from the mount.

6 To remove the mount from windshield, release the locking clamp and pull the tab on top of

the EZ Mag Mount.

EZ Mag Mount Care Instructions:

To clean your EZ Mag Mount, simply rinse under warm water, gently wipe off any debris and

allow to air dry.