Installation guide

QNX4 Installation
CAN-API Installation
Manual • Doc. No.: C.2001.21 / Rev. 3.0 •
© 2000-2007 esd gmbh
Page 101 of 112
5.2.1.2.2 Installation of PCI-Boards
First install the module hardware.
Log in as ‘root’.
Start the resource manager (example CAN-PCI/331): ‘
c331 &
’
Now an output similar to the one below has to appear on the screen:
C331[0]: Using Interrupt 12
C331[0]: "CAN_PCI331" with 2 Nets identified
C331[0]: Hardware-Version=1.1.00
C331[0]: Firmware-Version=0.c.00
C331[0]: Driver-Version =1.0.00
C331[0]: Net 0: Successfully created
C331[0]: Net 1: Successfully created
Note:
Depending on the module the resource manager might be called by means of different
commands. The character combination ‘
c331
’ , as shown in the example above, has to be
substituted for other modules as shown below:
CAN Module Entry Syntax QNX4
CAN-PCI/200
CPCI-CAN/200
CAN-PCI/266
-
CAN-PCI/331
CPCI-CAN/331
PMC-CAN/331
c331
-... has not been implemented yet
Table 36:
Input syntax when calling the resource manager on PCI boards