Installation guide

Windows NT 4.0 Installation
Manual • Doc. No.: C.2001.21 / Rev. 3.0 •
© 2000-2007 esd gmbh
CAN-API Installation
Page 26 of 112
2.5 Windows NT 4.0 Installation
2.5.1 Installation of Software Drivers for the Host CPU
2.5.1.1 Starting Installation
When updating it is necessary to de-install the old driver version, as shown in section 2.5.1.5.
Attention:
The complete installation, configuration and starting the driver can only be done with
administrator rights on the Windows NT computer!
You will find the device driver on the CD-ROM in a corresponding sub-directory.
For installation the CD-ROM containing the device driver has to be inserted into the drive and the
installation program has to be executed. This can either be achieved by directly calling the program
setup.exe
or by pressing the
install
icon in dialogue box
add/remove program properties
in the
folder
control panel
.
The following installation process is interactive-controlled. In the course of installation you can choose
between one of three configurations:
Configuration Description
Typical Driver, DLL and program to update the local firmware.
Compact Driver, DLL and configuration programs.
Custom User-defined configuration.
Tab le 5:
Configuration selection
After the installation and before the start of the driver, the computer has to be re-booted. This can be
done directly from the setup program after the installation is finished.
Continue with the installation of the SDK, as described on page 53.