Installation guide

Windows NT 4.0 Installation

CAN-API Installation

Manual • Doc. No.: C.2001.21 / Rev. 3.0 •

Page 27 of 112

2.5.1.2 Calling Configuration Program CAN Control

For the configuration of the driver the program CAN Control is part of the product package. It is called

from the system control.

The following figures show a system with four esd-CAN modules (CAN-ISA/331, CAN-PCI/331,

CAN-PCI/200 and CAN-PCC) exemplary. CAN Control only displays the esd-CAN modules which

are installed in the system. If you have only installed one CAN module, only one file card is shown.

The following figure shows the setting options for CAN-

ISA

modules:

The following figure shows the setting options for the CAN-

PCC

module.