Installation guide

Windows NT 4.0 Installation
Manual • Doc. No.: C.2001.21 / Rev. 3.0 •
© 2000-2007 esd gmbh
CAN-API Installation
Page 28 of 112
Under
Interface
you enter the number of the CAN module for which the settings are to be valid. In
Base
Net
a base network number is assigned to the CAN module. If a module has got more than one physical
CAN interface, the first gets the logical network number specified in
Base Net
, and the following are
counted up from there.
Attention:
The user has to make sure that no number is assigned twice when logical network
numbers are assigned!
Enter your hardware configuration regarding the I/O port address for each CAN module, set the
interrupt level and click OK. The driver is now installed and configured.
The following figure shows the setting options for CAN-
PCI
modules. Here, only logical CAN
networks are assigned: