Installation guide

Windows NT 4.0 Installation

Manual • Doc. No.: C.2001.21 / Rev. 3.0 •

CAN-API Installation

Page 30 of 112

2.5.1.4 Starting the Driver

In order to start the driver, the command

net start xxxx

is to be entered in the command line

first.

For the various CAN modules the drivers are called as follows:

CAN Module Commands for Starting the Drivers

CAN-ISA/200

net start c200i

CAN-PC104/200

(SJA1000 version)

CAN-ISA/331

net start c331i

CAN-PC104/331

CAN-PCI/200

net start c200

CAN-PCI/266

CPCI-CAN/200

PMC-CAN/266

CAN-PCI/331

net start c331

CPCI-CAN/331

PMC-CAN/331

CAN-PCI/360

net start c360

CPCI-CAN/360

CAN-PCC

net start cpcc

Tab le 6:

Commands for starting the driver

If the driver starts without complication, the start type of the driver can be set in dialogue

system

control/devices

from

manual

automatic

, so that the driver is activated after each reboot and can also

be used by users without administrator rights.

If a problem arises when starting the driver, the error cause can be taken from the

system event log file

of Windows NT 4.0.