Installation guide

Windows 95/98/ME Installation

CAN-API Installation

Manual • Doc. No.: C.2001.21 / Rev. 3.0 •

Page 37 of 112

Click

If the system does not propose settings:

If the system says that it does not have any resources for the CAN-ISA board, the installation

has to be completed nevertheless. In this case the resources in the system have to be distributed

again manually by means of the device manager after the installation.

9. The successful installation of the software driver is shown by the following window:

10. In order to complete the software installation you have to shut down your computer after

terminating all applications which are still open!

Then switch off the computer and

install the hardware now

as described in the hardware

manual! Compare the default setting to the setting selected under point 8 and change the

jumpers (or coding switches, depending on board type), if necessary.

11. Switch on the computer again after the installation and restart Windows 95. The driver is

automatically loaded by Windows 95. The device manager now has the new device class

CAN

Controller

under which all

esd

CAN boards can be shown and configured.

Now install the SDK, as described on page 53. The SDK contains the files that are necessary

for the development of your own applications and it contains the monitor program CANreal.