Installation guide

Windows 95/98/ME Installation
CAN-API Installation
Manual • Doc. No.: C.2001.21 / Rev. 3.0 •
© 2000-2007 esd gmbh
Page 41 of 112
2.6.2.4.3 Changing the Resource Settings by Means of the Device Manager
1. Select the device class
CAN Controller
in the device manager by double clicking.
The tree branches and shows all devices of this type available in your computer.
2. Double clicking a device opens up its property window.
Click the
Resources
icon under the device properties.
The
Conflicting Device List
shows the settings of other devices which are conflicting the current
setting of the CAN-ISA board.
3. Select the setting which is to be changed, for instance the interrupt level, under
resource type
. Click
the
Change setting
icon in order to keep the changed values.
Changes can only be made, if the option
Use automatic settings
has been deactivated.
The
Interrupt
and
Input/Output-range
(address space) settings can be changed independently.
The dialogue box
Input/Output range
shows the various settings which are supported. An interrupt
which is marked by an asterisk (*) signifies that this interrupt is already used by another device.
After clicking the
Change setting
icon an error message might appear which states that the resource
setting cannot be changed. In this case you have to select other settings until the system accepts one
of the chosen settings.
4. Select settings which are not conflicting other devices and click ‘OK’.
Remember that the I/O-
range setting by jumper (or coding switches, depending on the board type) has to comply with
the selected setting!
5. Finish Windows 9x/ME, then change the hardware settings of devices which have been configured
again and restart Windows 9x/ME.