Installation guide

Installation of the EtherCAN Module Under Windows
CAN-API Installation
Manual • Doc. No.: C.2001.21 / Rev. 3.0 •
© 2000-2007 esd gmbh
Page 51 of 112
2.10 Installation and Confi
g
uration of the EtherCAN Module
The EtherCAN client driver supports Windows NT, Windows 2000, Windows XP, Windows Server
2003 and Windows Vista (32- and 64-bit versions). This chapter explains the installation and general
configuration of the module.
Note:
Before host software installation the EtherCAN module should be assigned an IP address
within the subnet.
The description of the IP-address assignment and the further configuration via the
integrated Web-server are described in the manual ‘EtherCAN, Hardware Manual’.
2.10.1 Installation
1. Start the installation program
setup.exe
which is located in the directory
EthetCAN/Win32
of the CAN driver CD
2. Follow the instructions of the
installation program.
3. When the
Setup Type
is requested,
please choose
Typical.
4. The success or failure of the
installation will be displayed at the
end of installation.