Installation guide

LynxOS Installation

CAN-API Installation

Manual • Doc. No.: C.2001.21 / Rev. 3.0 •

Page 77 of 112

4.2.2 Sequence of Installation Under LynxOS

1. Unpacking the Archive

In order to unpack the tar-archive the following command has to be called:

tar -xvf c331-lynx-v1.0.0.tar

Note:

‘

c331

’ has to be entered for the CAN-PCI/331 module. For other modules the

character combination shown in the following table has to be entered:

CAN Module Entry

VME-CAN2

ican2

VME-CAN4

ican4

CAN-ISA/331

CAN-PC104/331

c331i

CAN-PCI/331

CPCI-CAN/331

PMC-CAN/331

c331

Table 18:

Input syntax for unpack the archive

2. Loading the CAN Driver:

instcan c331

(2.B Unloading the CAN Driver:)

The CAN driver has to be unloaded, e.g., after an update of the local firmware in order to

reset the processor. In the CAN-PCI/331 module, e.g., the driver can be unloaded by the

following command:

instcan -u c331