Safer Choice Standard

12346 Valley Blvd, Suite A El Monte California U.S.A. 91732
Office: 626-579-3889 www.eleding.com Email: [e-mail] Page 3 of 4
– Maintain the labels and nameplates on the lights and power generators. These carry important information.
If unreadable or missing, contact our support with original order information when you have issue on products.
 WARNING:
– Do not use lights and power generators or appliance that is damaged or modified. Damaged or modified
internal batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
– Do not remove cover. No user serviceable parts inside.
– Do not tamper or disassemble the lights and power generators to attempt service. Incorrect reassembly may
result in a risk of fire, electric shock or personal injury.
– For service information please contact our Support Team at 1-877-579-3889. Please have your order
information and model number available when service, repair or replacement is required.
– Never place fingers or hands inside the product.
 WARNING:
– To reduce the risk of injury or damage, avoid contact with any hot surface.
– Do not use the lights and power generators near sources of high heat or fire. Exposure to fire or temperature
above 266°F (130°C) may cause explosion.
– Do not discharge the lights and power generators battery in temperatures below -4°F (-20°C) or above 125°F
(52°C).
– Follow all charging instructions and do not charge the lights and power generators outside the temperature
range specified in the instructions. Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.
When charging the lights and power generators:
– Always charge the lights and power generators’ internal battery in a well-ventilated area.
– Do not use the AC charging cable outdoors.
– Do not expose AC charging cable to oil, oil vapor, grease, gasoline, gasoline vapors or other caustic
substances that may damage the AC charging cable.
– Do not charge lights and power generators in rain, snow, damp or wet locations.
– Do not overcharge and over-discharge the lights and power generators internal battery.
– Always connect to properly grounded outlets for AC power source most.
– Never use lights and power generators or charger in the presence of explosive atmospheres (gaseous fumes,
dust or flammable materials).
– Never leave the lights and power generators unattended while charging. If the internal battery smokes, or
gives off an odor during charging, terminate charging immediately.
– During charging/discharging, if the lights and power generators battery becomes hot to the touch, stop
charging. Allow battery to cool before resuming.
– Always unplug charger when not in use or without monitoring control.
– To reduce the risk of electric shock, always unplug charger before cleaning or maintenance. Do not allow
water to flow into plug. Use a Ground Fault Circuit Interrupter (GFCI) to reduce shock hazards.