Full Product Manual
If you need to use both hand-hold controller and wall controller for the
same light, please don't use this function, directly use the following copy
function.
2.4G Wireless Dimming & CCT Tunable Remote Controller
THE WALL TYPE REMOTE CONTROLLER
Power the light off then power it on, the last saved brightness (which is saved by the button "ON") and the last saved color temperature (which is
saved by the button "ON" or "OFF") will be displayed by default. The defaulted factory setting of the light is 100% brightness and 4000K.
After 10s of each operation the controller will enter standby power saving mode. If you need to make adjustments, simply press the "ON" button, the
indicator will flash to show it is working. (If the controller is under working mode, the indicator will flash no matter which button is pressed).
The matching method of hand-hold remote controller and wall-type remote controller, the wall controller can
copy some of the functions of the hand-hold controller by the following method.
1
2
3
4
NO Grouping Hand-hold controller Wall-type controller
5
1
2
3
4
ALL
1+ID
2+ID
3+ID
4+ID
ID
ON+CCT
ON+CCT
ON+CCT
ON+CCT
ON+CCT
A
Light code combination matching button
Brightness adjustor
Pressing the ‘ON + OFF’ buttons simultaneously will keep the remote controller’s
indicator on, turn on the light and release the buttons after the light has been on
for 2s completing the matching process. Matching code for several lights together
is available.
Press the ‘CCT’ button, the color temperature will cycle between 3000k/3500k/
4000k/5000k.After shutting down/turning off the current color temperature will
be saved.
A
+
Turn on Turn off
Wall-type remote controller cannot be used directly as a switch, it should be
used together with the switch.
Long pressing (6-9 seconds) the button "ON" until the light goes out, the current
brightness and color temperature are automatically saved. Turn off lights then turn
on, the last saved brightness and color temperature will be displayed by default.
Turn off the light to save the current color temperature then turn on the light, the
last saved color temperature will be displayed by default.
E E Systems Group, Inc. 12346 Valley Blvd, Suite A El Monte California U.S.A. 91732
EE Systems Group Inc. www.eleding.com , info@eesgi.com. 1-877-579-3889 (M-F, 10am-5pm PST), v042021