Instructions / Assembly

2.4G Wireless Dimming & CCT Tunable Remote Controller
THE HANDHELD REMOTE CONTROL
Turn on
How to set the initial Remote Control code to operate the LED Panel Light(s)
How to erase the Remote Control code to set up different LED Panel Light(s)
How to Control Groups of LED Panel Lights
How to Save the default brightness level and color temp
Turn OFF the wall switch or circuit breaker. Then press and hold the ID button
until the tiny RED LED indicator is flashing on top of the Remote Control.
Then turn ON the wall switch or circuit breaker and release the ID button after
the LED Panel Light(s) flashes. Setup complete.
After enabling the initial Remote Control code to operate the LED Panel
Light(s), the remote control can be programmed to separately control up to
four LED Panel Light groups (1, 2, 3, 4) as follows: Turn OFF the wall switch
or circuit breaker for the desired Group 1. Press “1” button, Turn ON the wall
switch or circuit breaker for the desired Group 1 and release the Group “1”
button after the Group 1 LED Panel Lights flash. Group 1 programmed.
Repeat process to set up other groups.
5000K
4000K
3500K
25% brightness
Increase brightness Decrease color temperature
Increase color temperatureDecrease brightness
50% brightness
75% brightness
100% brightness
3000K
All Groups are selected
Turn off
Save
+
Press the botton simultaneously, then turn on the light, the
light flash to finish releasing the code on the lights.
+
Select the desired brightness level and color temp. Then press and hold the SAVE
button for a few seconds until the LED Panel Lights shut OFF. The settings are now
saved. Each time you turn ON the wall switch or circuit breaker, the LED Panel
Lights will utilize the saved brightness level and color temp
The Remote Control provides flexible adjustments for dimming the LED Panel
Light and selecting the desired color temp. Handheld remote control should
operate with wall main ON-OFF switch
After selecting the desired settings, push the Remote Control OFF button to
save them as default settings until the next setting change. Then the wall
main switch ON-OFF as normal operation in most time
5000K 4000K 3500K 3000K
COLOR(CCT)
BRIGHTNESS
GROUPING
Power OFF the LED Panel Light and then power it ON. The last saved brightness (which is saved by the button
“SAVE”) and the last saved color temperature (which is saved by the button “SAVE” or “OFF”) will be displayed by
default. The defau factory setting of the light is 100% brightness and 4000K.
E E Systems Group, Inc. 12346 Valley Blvd, Suite A El Monte California U.S.A. 91732
EE Systems Group Inc. www.eleding.com , [e-mail]. 1-877-579-3889 (M-F, 10am-5pm PST), v042021