Owner Manual

This driver’s low-profile plastic enclosure enables easy and safe
installation, making it the perfect choice for low-voltage under
cabinet lights, tape lights, and various LED fixture installations
Precautions Before Installing
Check the label to ensure the driver has the proper input voltage
and wattage for the job.
NEVER COMBINE a 120-volt wall dimmer with a 24-volt DC
dimmer switch, an RGB controller or EShine touchless dimming
function in the same circuit.
SHOCK HAZARD! If direct wiring this LED driver to a 120-volt
circuit with an AC dimmer, turn off the power at the circuit breaker
before installing. Failure to do so may result in serious injury or
death.
MAINTAIN POLARITY: Observe the polarity of the 24-volt DC
output and the device or lighting to which you’re connecting.
Failure to maintain the same polarity could damage LED lighting,
dimmers, and RGB controllers. Always connect positive (+) to
positive and negative (–) to negative.
The transformer must be installed in a well-ventilated area free
from explosive gases and vapors.
The total wattage of all LED fixtures connected to this LED driver
must not exceed the 60 Watt rating of this unit. If you don’t know
the wattage rating of your lighting, ask the manufacturer.