Installation manual

ESI Communications Servers Hardware Installation Manual ESI-100
G.4
3. A cable is attached to Connector J1 of the E2 port card.
Connect the cable’s other end to Connector J2 of the
cabinet’s existing port card.
4. Secure the E2 port card to the cabinet (Fig. PC-2).
If it’s going into the top slot, use five screws.
If it’s going into the bottom slot, use five standoffs appropriately:
• 7/16-in. standoffs — Between the Base Cabinet and the
first card.
• 3/4-in. standoffs — Between the first and second card
in the Base Cabinet.
• 1-in. standoffs — Between port cards in the
Expansion Cabinet.
Use the screws that ship with the E2 port card to secure
the card to the standoffs. (You may have leftover screws.)
DON’T overtighten the standoffs; it will strip the
plastic bosses.
5. Put the top cover back on the cabinet, and then replace
the locking screw to secure the cover on the cabinet.
(In other words, perform the reverse of Step 2.)
6. To remove the E2 port card, follow steps 2–5 in reverse order.
Fig. PC-3 (right) shows the configuration of a fully loaded ESI-100.
Note: For adding an ASC as the fifth card, see page G.8.
Fig. PC-2
Fig. PC-3