Top Quality 5” Active Studio Reference Monitor User’s Guide
ESI - Copyright © 2014 Revision 3, May 2014 www.esi-audio.
ESI aktiv 05 INDEX 1. Introduction .................................................................................................................................. 4 2. Basics & Installation .................................................................................................................... 4 Unpacking / Handling ................................................................................................................................................ 4 Connection ...................
ESI aktiv 05 1. Introduction Congratulations on your purchase of the ESI aktiv 05. The aktiv 05 top quality near field reference monitor has been developed especially for high level home studios and special project studios.
ESI aktiv 05 3. Placement The placement of monitoring speakers is very critical and can compromise their performance. This is a general rule for every loudspeaker. To monitor with aktiv 05 utilizing their maximum capabilities, an appropriate listening environment and a correct placement are important. Typically you would be using 2 units of aktiv 05 as one stereo pair – or more in surround setups (i.e. in a 5.1 setup you would use 5 units of aktiv 05 together with a subwoofer). Stereo / 2.
ESI aktiv 05 5.1 Positioning In a 5.1 surround set, the center speaker should ideally be placed on top of the subwoofer. If this is not possible, the subwoofer can be moved to the left or right but should be as close as possible. The rear surround speakers should be positioned around 110° from the center speaker (all with the same distance x). 7.1 Positioning In a 7.1 surround set, the center speaker should also ideally be placed on top of the subwoofer or as close as possible.
ESI aktiv 05 Orientation It’s very important to place the aktiv 05 vertically. Never place them horizontally. Comments Please also make sure to not place any obstacles that may block the flow of air or that could generate sound reflections (especially highly reflective material including glass or metal) in front of the monitor. Also, don’t put plants in pots on top or too close to your monitors. Keep a certain distance to the wall behind the speaker, as it could block air flow. 4.
ESI aktiv 05 Rear Panel 1. XLR input – this connector accepts balanced XLR input connections (optimised for +4dBu). XLR input is wired like this: INPUT SIGNAL XLR CONNECTIONS + Shield PIN 2 PIN 3 PIN 1 2. TS input – this jack accepts TS input connections, unbalanced (optimised for -10dBV). The TS input is wired like this: INPUT SIGNAL TRS CONNECTIONS Signal Shield Tip Sleeve The TS input should not be used with balanced TRS signals.
ESI aktiv 05 3. vent port – aktiv 05 is a vented box speaker system with a vent port on the rear panel. Make sure you are not blocking the vent port (i.e. by putting the speaker too close to a wall) or the sound colour will be changed. 4. volume control knob – use the volume control knob to set the proper input level from the sound source. Make sure to setup all speakers accordingly.
ESI 10 aktiv 05