Use and Care Manual

7
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
ENGLISH
Operator's Manual
22100, 25501
|
EVO™ Crossover Ice Shelter
10. [ FIGURE 10 ]
With both hub panels open, lift the rear of
the top panel and pull the shelter skin over
the assembled sled and pole assembly.
11. [ FIGURE 11 ]
Rest the rear of the top panel on assembled
frame pole assembly.
12. [ FIGURE 12 ]
Attach the skin assembly to the frame pole
assembly using the velcro straps sewn at
the rear of the top panel seam. There will
be (4) individual velcro attachments at
this location [(2) at center, and (2) at the
corners)].
NOTE: Once the skin is attached to the frame
pole assembly, make sure all the fabric panels
are laying at and the skin assembly is
centered in front of the sled.
EDGE TRIM ATTACHMENT
13. [ FIGURE 13 ]
Locate the center of the edge trim (#22253)
by folding it in half. Next, locate the center
rear of the shelter along the sled lip and
attach the edge trim center at that center
point.
Be sure to keep the skin taut as you work
the remainder of the edge trim into place
around the sled corners.
Screw in place with (12) 6 x 3/8 screws
provided, spaced evenly along the length
of the edge trim.
FIGURE 12
FIGURE 11
FIGURE 10
SKIRT
SKIN
SLED
EDGE TRIM
#6  3/8” SCREW
EDGE TRIM
BACK OF SLED/SKIN
FIGURE 13