7 Ar d is am , In c . C u m b e rl a nd, Wisconsin 5482 9 01-8 0 34 5-6 00 Power Ice Auger Operator's Manual TM BARRACUDA BARRACUDA PLUS TM LBL-ESK 5-6 00 7 Ar d is am , In c . C u m b e rl a LBL-ESKS 9 nd, Wisconsin 5482 4 0-3 1-80 LBL-ESK Ar d is am , In c . C u m b e rl a LBL-ESKS 9 nd, Wisconsin 5482 4 0-3 1-80 5- 6 00 7 Models 8903B 893B8 893BQ8 893BQ9 893B10 Models 9003B 9003B8 9003BQ8 9003BQ9 9003B10 IB-893B/9003B-06E Rev.
INTRODUCTION, REGISTRATION AND WARRANTY THANK YOU . . . REGISTRA TION REGISTRATION for purchasing an Eskimo® Power Ice Auger from Ardisam, Inc. We have worked to ensure that it meets high standards for usability and durability. With proper care, your auger will provide many years of service. Please take the time to read this manual carefully to learn how to correctly operate and maintain your auger. Congratulations on your investment in quality.
SAFETY Owner's Responsibility Important Safety Precautions Accurate assembly and safe and effective use of the auger is the owner's responsibility. • Read and follow all safety instructions. • Carefully follow all assembly instructions. • Maintain the auger according to directions and schedule included in this Eskimo operator’s manual. • Ensure that anyone who uses the auger is familiar with all controls and safety precautions. Please read this section carefully.
OPERA TION OPERATION OPERA TION OPERATION (Refer to your Tecumseh Operator’s Manual for further information on fuel.) CAUTION 2. Mix fuel in a 1 or 2 gallon container approved for gasoline. Please do not start your auger until you have read the Tecumseh Operator’s Manual that came with your engine, and the section in this manual titled Safety. If you have read these, follow the steps below to start your auger. Always perform this pre-start checklist before starting the engine. 3.
MAINTENANCE AND ST ORAGE STORAGE CAUTION To prevent accidental starting: Avoid injury! Engine must be turned off and cool, and spark plug wire must be removed from spark plug before checking and adjusting engine or equipment. Engine can overheat and become damaged if debris blocks the cooling fins or recoil housing. Refer to the Tecumseh Operator’s Manual included in your parts packet for information on engine maintenance.
SERVICE TING AND REP AIR SERVICE,, TROUBLESHOO TROUBLESHOOTING REPAIR SERVICE INFORMA TION INFORMATION ICE POINT REPLACEMENT IN CASE OF A SERVICE PROBLEM, DO NOT SEND UNIT BACK TO RETAILER. CONTACT ARDISAM, INC. AT 1-800-345-6007. At Ardisam, we build quality and durability into the design of our products; but no amount of careful design by us, and careful maintenance by you, can guarantee a repair-free life for your auger.
SERVICE TING AND REP AIR SERVICE,, TROUBLESHOO TROUBLESHOOTING REPAIR ORDERING REP AIR PARTS REPAIR Please include the following information with your order: Parts can be obtained from the store where your auger was purchased or direct from the factory. To order from the factory, call or write to: 1. Part numbers 2. Part description 3. Quantity Ardisam, Inc. 4. Model number and serial number 1690 Elm Street, Cumberland, WI 54829 1-800-345-6007 • 1-715-822-2415 Email info@ardisam.com www.ardisam.
BARRACUD ARTS LIST BARRACUDAA PPARTS 2 Page 8
BARRACUD ARTS LIST BARRACUDAA PPARTS MINIMUM ORDER ........................................................................... $10.
BARRACUD US PPARTS ARTS LIST BARRACUDAA PL PLUS Page 10
BARRACUD US PPARTS ARTS LIST BARRACUDAA PL PLUS MINIMUM ORDER ........................................................................... $10.
Ardisam, Inc. 1690 Elm Street, Cumberland, WI 54829 1-800-345-6007 • 1-715-822-2415 Email info@ardisam.com www.ardisam.