User's Manual

Elevator Trim Lever
Aileron Trim Lever
Reverse Switches
Charging Indicator
Power Switch
Left Control Stick
Throttle Trim Lever
Rudder Trim Lever
Right Control Stick
Throttle Cut SwitchSwitch
Beginner / Experienced Mode
ECH6 Transmitter (RTF Version) - Left hand throttle Mode2
LCD Voltage Indicator: In the power-on state, the current transmitter battery voltage is displayed.
Beginner/Experienced Mode Switch: LO is Beginner Mode, HI is Experienced Mode.
Throttle Cut Switch: Red dot position is ON, green dot position is OFF.
Left Control Stick: UP and DOWN are Throttle Control, Left and Right are Rudder Control.
Right Control Stick: UP and DOWN are Elevator Control, Left and Right are Aileron Control.
Elevator Trim Lever: Fine tuning the Pitch Control
Rudder Trim Lever: Fine tuning the Rudder Control
Throttle Trim Lever: Fine tuning the Throttle Control
Aileron Trim Lever: Fine tuning the Aileron Control
Power Switch: Push up to power on, push down to power off.
Charging Indicator: ECH6 transmitter (RTF version) uses Alkaline Battery, so the transmitter charging
function is not available.
(Transmitter charging function is only available to LiPO batteries and NiMH batteries)
Reverse Switches: Control direction of movement of servos connected to the receiver.
AIL Reverse Switch: Control direction of movement for Channel 1, NOR is Normal, REV is Reverse.
ELE Reverse Switch: Control direction of movement for Channel 2, NOR is Normal, REV is Reverse.
THR Reverse Switch: Control direction of movement for Channel 3, NOR is Normal, REV is Reverse.
RUD Reverse Switch: Control direction of movement for Channel 4, NOR is Normal, REV is Reverse.
Caution: Using the THR mode prudently. Incorrect setting can cause left stick (throttle stick work vertically)
operate reversely (the aircraft motor will operate maximally when left stick push to bottom). Changing the
throttle control direction only affect the signal sent from the controller, and it will not affect the motor operate
direction.
8
EN
LCD Voltage Indicator