Operating instructions
18
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
P
P
r
r
o
o
c
c
e
e
d
d
u
u
r
r
e
e
s
s
Setting the time
Press and hold the CLOCK button.
Press D
AY button to select the correct day.
Press HOUR button to select the correct hour.
Press MIN button to select the correct minutes.
When the MIN button is released the time will be set.
Holding down or repeatedly pressing the appropriate button will
advance the days, hours and minutes.
Programming of Switching Times
The Auto Time Switch has the capacity for 8 ON/OFF switches.
By using the b
locks of days available, you can save program
capacity. The block days are:
MO, TU, WE, TH, FR, SA, SU – Individual days of the week
MO, TU, WE, TH, FR
SA, SU
MO, TU, WE, TH, FR, SA
MO, WE, FR
TU, TH, SA
MO, TU, WE
Programmable Timer Instructions
Each ON time and each OFF time, the da
ys, hours and minutes
must be set.
Press the TIMER button once to set the first ON time – you will
see “on” and the number “1” appears.
Enter the first ON time.
Press the DAY button to choose the required day or block of
days.
Set the hour and minutes using the HOUR and MIN buttons.
Press TIMER button to save first on time and are ready to set
first off time you will see “OFF” and the number “1” appear.
Use the DAY, HOUR and MIN buttons as above.
Press the TIMER button to save off time.
Repeat the same steps for the remaining 7 ON and OFF set-
tings as desired.
When you have set the required ON/OFF settings, press the
CLOCK button to return the display to the clock.
The timer is now ready to operate.
14.5mm
9/16”
K (15)
15 (K)
31
Ø
Ø
P/N 5670007 (12v)
P/N 5670008 (24v)
• Mount switch in a location where it is easily accessible
• Mount using hardware supplied
• Connect the switch harness to the connector at the heater
and run the harness to the switch location
• Cut harness to length at the switch and install terminals
• Connect wiring as described below
Brown- 31 Power from battery “-”
Red- K(15) Power from battery “+”
Yellow-15(K) Switch control to the heater
Blue/White Diagnostic from heater (disregard - tape end
and tie off to the side)
Push/Pull Switch
Programmable Timer
A
UT
O
M
A
N
U
A
L
R
E
S
E
T
C
L
O
C
K
T
I
M
E
R
D
A
Y
H
O
U
R
M
I
N
M
A
N
U
A
L
P/N 5670100 (12v)
P/N 5670099 (24v)
IMPORTANT: This electronic timer has a maximum loading
printed on the rating label and under no circum-
stances should this be exceeded.
Features:
• Up to 8 ON and OFF switches a day/56 ON and OFF
switches per week
• Option to program individual days or 8 different weekday
groups
• Minimum switching period of one minute
• Summer/Winter time changeover
• Easy to read LCD display
• Manual Override button
• Battery Back-up
Note: As soon as you have connected 12 volts you will
have to push down the RESET button to activate
the timer.
Yellow (Signal to Heater)
a
3
)
a
5
)
a
4
)
5
4
5670100 - 12 Volt
5670099 - 24 Volt
Programmable
Timer
3
2
1
Brown (-)
Red (+)
A
U
T
O
M
A
N
U
A
L
R
E
S
E
T
C
L
O
C
K
T
I
M
E
R
D
A
Y
H
O
U
R
M
I
N
M
A
N
U
A
L
Programmable Timer
Note: You can check the settings you have programmed
by pressing the TIMER button repeatedly. Each set
ting will appear on the screen.
Note: Switch light glows when pulled out and is off when
pushed in.