Operating instructions

Note: It is imperative to keep to the correct laying order for
the sensor lead harness (19) and the glow plug leads.
The glow plug leads may not be laid underneath the
sensor lead harness (19).
The sensor lead harness (19) must be laid in the area
of the fuel pipe as shown in Figure 20.
The side cover (3) is conical at the bottom to simplify
installation.
36
M
M
a
a
i
i
n
n
t
t
e
e
n
n
a
a
n
n
c
c
e
e
,
,
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
&
&
R
R
e
e
p
p
a
a
i
i
r
r
s
s
Repair step 2
Install combustion chamber
Figure 19
• Use 3 screws (9) M5 x 16 to fix the combustion chamber (8).
Tightening torque M5 x 16 screw.
Lay sensor lead harness and leads of the glo
w plugs
Figure 20 and 21
• First lay the sensor lead harness (19) in the side cable duct,
then lay the 4 leads of glow plugs 1 (5) and 2 (6) in the cable
duct.
Lay the sensor lead harness (19) and the glow plug leads to
the 14-pin connector (29 - shown in page 33).
• Position the side cover (3) on the middle of the control box /
blower unit (10) and push into the cable duct guide.
Assemble the control box/blower unit and jacket