User's Manual

Disclaimer and Copyright Notice

Information in this document, including URL references, is subject to change without notice.

THIS DOCUMENT IS PROVIDED AS IS WITH NO WARRANTIES WHATSOEVER, INCLUDING ANY

WARRANTY OF MERCHANTABILITY, NON-INFRINGEMENT, FITNESS FOR ANY PARTICULAR

PURPOSE, OR ANY WARRANTY OTHERWISE ARISING OUT OF ANY PROPOSAL,

SPECIFICATION OR SAMPLE. All liability, including liability for infringement of any proprietary

rights, relating to use of information in this document is disclaimed. No licenses express or

implied, by estoppel or otherwise, to any intellectual property rights are granted herein.

The Wi-Fi Alliance Member logo is a trademark of the Wi-Fi Alliance.

All trade names, trademarks and registered trademarks mentioned in this document are

property of their respective owners, and are hereby acknowledged.

Espressif IOT Team

http://bbs.espressif.com

The OEM or final integrator must ensure that FCC labeling requirements are met. This includes an

additional label on the outside of the final product housing with the following contents:

Company Name

Model:ESP32

FCC ID:2AC7Z-ESP32

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

To satisfy FCC RF Exposure requirements for this transmission devices, a separation distance of

20cm or more should be maintained between the antenna of this device and persons during

operation. To ensure compliance, operation at closer than this distance is not recommended. The

antenna(s) used for this transmitter must not be co‐located or operating in conjunction with any

other antenna or transmitter.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

The modular transmitter must be equipped with either a permanently affixed label or must be

capable of electronically displaying its FCC identification number：

(A) If using a permanently affixed label, the modular transmitter must be labeled with its own FCC

identification number, and, if the FCC identification number is not visible when the module is

installed inside another device, then the outside of the device into which the module is installed

must also display a label referring to the enclosed module. This exterior label can use wording such

as the following: “Contains Transmitter Module FCC ID: 2AC7Z-ESP32” or “Contains FCC ID:

2AC7Z-ESP32.” Any similar wording that expresses the same meaning may be used. The Grantee

may either provide such a label, an example of which must be included in the application for

equipment authorization, or, must provide adequate instructions along with the module which

explain this requirement. In the latter case, a copy of these instructions must be included in the

application for equipment authorization