User's Manual

ESP8266UserManual 
12 / 12Espressif SystemsJune 19, 2014
selectedabovetoone(target.bin).“Default”resettothedefaultconfig.
（3） MacAddress：MacaddressofESP8266.

AlsosetthejumperonthemotherboardasMTDO：0，GPIO0：0，GPIO2：1,the n
itwillenterdownloadmode.Stepsareasfollows:
(1) See the red boxes in the picture above, select the bin file to be burned ->fill in the
path ->check burning options.
(2) Set COM port and baud rate.
(3) Click "START" to start downloading.
(4) After the downloading, disconnect the power for the motherboard, and change the
jumper into operation mode. Re-connect the power for operation. Set the jumper
on the motherboard as MTDO：0，GPIO0：1，GPIO2：1 for operating mode.
Note: please disconnect the power when setting the jumper.

