Installation Instructions

FCC Label: The FCC ID is on the front of the device. It is easily visible.
The device FCC ID is 2AC7Z-EK057.
A label with the following statements must be attached to the host end product:
This device contains FCC ID: 2AC7Z-EK057.
The manual provides guidance to the host manufacturer will be included in the documentation that will
be provided to the OEM.
The module is limited to installation in mobile or fixed applications.
The separate approval is required for all other operating configurations, including portable configurations
and different antenna configurations.
The OEM integrators are responsible for ensuring that the end-user has no manual or instructions to
remove or install module.
The module is limited to OEM installation ONLY.
Module grantee (the party responsible for the module grant) shall provide guidance to the host
manufacturer for ensuring compliance with the Part 15 Subpart B requirements.
The host manufacturer is responsible for additional testing to verify compliance as a composite system.
When testing the host device for compliance with the Part 15 Subpart B requirements, the host
manufacturer is required to show compliance with the Part 15 Subpart B while the transmitter module(s)
are installed and operating. The modules should be transmitting and the evaluation should confirm that
the module’s intentional emissions are compliant (i.e. fundamental and out of band emissions) with the
Radio essential requirements. The host manufacturer must verify that there are no additional
unintentional emissions other than what is permitted in the Part 15 Subpart B or emissions are complaint
with the Radio aspects.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user’s
authority to operate the equipment.