Installation Instructions


FCCLabel:TheFCCIDisonthefrontofthedevice.Itiseasilyvisible.
ThedeviceFCCIDis2AC7Z‐ESP32JCIR.
Alabelwiththefollowingstatementsmustbeattachedtothehostendproduct:
ThisdevicecontainsFCCID:2AC7Z‐ESP32JCIR.
Themanualprovidesguidancetothe
hostmanufacturerwillbeincludedinthedocumentationthatwill
beprovidedtotheOEM.
Themoduleislimitedtoinstallationinmobileorfixedapplications.
Theseparateapprovalisrequiredforallotheroperatingconfigurations,includingportableconfigurations
anddifferentantennaconfigurations.
The OEM integrators are responsible for ensuring that
 the end‐user has no manual or instructions to
removeorinstallmodule.
ThemoduleislimitedtoOEMinstallationONLY.

Module grantee (the party responsible for the module grant) shall provide guidance to the host
manufacturerforensuringcompliancewiththePart15SubpartBrequirements.

The host
manufactureris responsible foradditional testing to verify complianceas a composite system.
When testing the host device for compliance with the Part 15 Subpart B requirements, the host
manufacturerisrequiredtoshowcompliancewiththePart15SubpartBwhilethetransmittermodule(s)
areinstalledandoperating.Themodules
shouldbe transmittingandtheevaluationshouldconfirm that
themodule’sintentionalemissions arecompliant(i.e.fundamentalandoutofband emissions) withthe
Radio essential requirements. The host manufacturer must verify that there are no additional
unintentionalemissionsotherthanwhatispermittedinthePart15SubpartB
oremissionsarecomplaint
withtheRadioaspects.

CAUTION:
Anychangesormodificationsnotexpresslyapprovedbythegranteeofthisdevicecouldvoidtheuser’s
authoritytooperatetheequipment.

