The perfect water supply is here. The World’s Best Source of Water eSpring™ Water Purifier Owner’s Manual U.S.
Owner’s Manual Contents Important Safeguards ....................................................................1 Important Notes ............................................................................2 Introduction ..................................................................................3 Above the Counter Existing Tap Installation ........................................4 Below Counter Tap Installation .........................................................
Important Safeguards WHEN USING AN ELECTRIC APPLIANCE, BASIC SAFETY PRECAUTIONS, INCLUDING THE FOLLOWING, SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND/OR INJURY TO PERSONS: 1. 2. READ ALL INSTRUCTIONS BEFORE USE. If you still have questions concerning the installation or operation of your eSpring™ Water Purifier, contact Technical Support toll-free, on 1 800 022 034 (in Australia), or 0 800 113 444 (in New Zealand).
Important Notes The eSpring™ Water Purifier is designed for use only with cold, bacteriologically suitable (potable) water. 1. System tested and certified by NSF International against ANSI/NSF Standard 42, 53, 55. See Performance Data Sheet for individual contaminants and reductions performance, page 16. 2. This Class B system conforms to ANSI/NSF 55 and contains an ultraviolet lamp that requires replacement at intervals in accordance with the manfacturer's instructions.
Introduction Installation of Filter Cartridge and connecting the Water Purifier to power Congratulations on your purchase of the eSpring™ Water Purifier. You have made a wise investment for you and your family and have taken an important step in improving the quality of your drinking water. Refer to the exploded view of the eSpring Water Purifier (Fig. 1) for assistance with part names.
Above the Counter Existing Tap Installation 2. This installation is quick and simple. The eSpring™ Water Purifier sits on the countertop with the diverter and tubing attached directly to your tap. Position the diverter onto the tap and turn the knurled revolving collar counterclockwise until the diverter draws up tight to the tap. If necessary, use one of the three supplied adapters to fit the diverter to your tap (Fig. 3). Fig. 3 Existing Tap Components (Fig.
5. Insert one tube support into the open end of each tube and mark the tubing with a line 18mm from the end of the 9.5mm tubing and 14.4mm on the 8mm tubing. (Fig. 5). 12. Turn on the tap and pull out diverter pin (Fig. 8). Water passes into the eSpring Water Purifier and Filter Cartridge. Fig. 8 Fig. 5 Diverter Pin 18 mm 14.4 mm Tube Support 6. 7. Remove the Top Shroud and Electronic Module from the eSpring™ Water Purifier.
Below Counter Tap Installation How to Mount the Auxiliary Tap The eSpring™ Auxiliary Tap Kit must be installed by a licenced plumber. All installations are to be performed according to local plumbing codes and regulations. 1. This installation uses a separate, counter-mounted Auxiliary Tap, which is supplied in the Auxiliary Tap Kit. With the eSpring Water Purifier below the counter, this installation allows maximum use of counter space, and there is no visible tubing.
7. Mark the ends of the blue and green hose with a line 18mm from each end (Fig. 11). Fig. 11 11. Securely connect the Union Quick Connector attached to the red hose to your cold water supply line (Fig 13). This connection will require additional parts to connect the red hose and is intended to be completed by a licenced plumber according to local plumbing codes and regulations. Fig. 13 Tap Handle (18 mm) 8. Remove the Top Shroud and Electronic Module from the eSpring™ Water Purifier. 9.
Checking for Leaks 1. Plug the power adapter into a suitable electrical outlet. NOTE: If you do not have a electrical power outlet under your sink, have one installed by a licenced electrical contractor. Double adapters or power boards should not be used. If you have a single power outlet and wish to run another appliance as well as the eSpring™, have the single power outlet changed to a double power outlet by a licenced electrical contractor.
Electronic module display The electronic display on the eSpring™ Water Purifier keeps track of the water usage litres and time since the last filter change. When properly plugged into an electrical outlet, the Purifier will display its status via the Electronic Module LED display.
Maintenance and Trouble Shooting Problem: Water flow rate has dropped significantly, but water pressure is normal. Problem: (Existing Tap only) Water continues to run after the diverter valve is shut off. Cause: Air in the water is causing an air bubble to form in the filter hous-ing. The larger the bubble, the longer the water will run after the diverter is shut off. Cause: The Filter Cartridge is probably clogged with particulates that prevent satisfactory water flow.
Problem: The filtered water is rusty or red in color. Problem: Lights not lit on the Electronic Module display. Cause: High content of soluble iron. Cause: Power outage Solution: The Filter Cartridge is not designed to remove soluble iron. Use of an iron filter or pre-filter prior to the Filter Cartridge may extend its life. Solution: You may continue to use filtered water. Contaminants will still be removed through the Filter Cartridge.
Filter Replacement 8. Loosen the Filter Retaining Ring (Fig. 16) by turning it counterclockwise. Continue turning the ring until it is completely loosened and remove. 9. With the Retaining Ring removed, lift the Filter Bracket (and the attached used Filter Cartridge) from the Base Housing using the lift handle to facilitate removal. The lift handle will break the main housing seal (Fig. 16). Place the Filter Bracket and attached Filter Cartridge in the sink. Removing the old Filter Cartridge 1.
Installing the New Filter Cartridge 1. Clean the Filter Bracket and the inside of the Base Housing with warm water and rinse thoroughly. If extremely dirty, a mild dishwashing detergent (such as DISH DROPS™ Dishwashing Liquid) and water may be used. DO NOT use any other cleaners or abrasive pads as they could damage the plastic housing and auxiliary tap. 2. Visually inspect the Filter Bracket and remove any debris that may interfere with sealing. 3.
Accessories and Replacement Parts Warranty Accessories and replacement parts may be ordered from your Amway Independent Business Owner (IBO). If you do not have an IBO, please call 1800-022-034 in Australia or 0800-113 444 in New Zealand to obtain information on an IBO near you. Information can also be accessed on the internet at www.eSpring.com. and www.a2k.com.au or www.a2k.co.nz. eSpring™ Water Purifier LIMITED WARRANTY Specifications eSpring™ Water Purifier: Model No.
5. Claim In order to make a claim under this Warranty in Australia, the Purchaser must contact Amway via telephone at Technical Support on 1800 022 034 or in New Zealand on 0800 113 444 for shipping and handling instruction BEFORE you return anything. Then return the claimed defective product to Amway together with a copy of a sales receipt or other proof of purchase and a brief description of the product defect.
NSF Performance Data Sheet The eSpring™ Water Purifier is listed with the NSF International. NSF International is an independent testing and certification agency established to set quality standards for a wide variety of home and industrial products. Many regulatory agencies, municipal water treatment officials and residential builders look for NSF International listing as certification that a product will meet high performance standards.
In addition, NSF International has verified the water treatment claims for this model for the reduction of specific substances which are not included in NSF/ANSI Standard 53 or Standard 42 as follows: Chemical Additional Contaminants EPA Priority Pollutants Chemical Acenaphthene Acenaphthylene Aldrin Anthracene Benzidine Benzo[a]anthracene Benzo[a]pyrene Benzo[b]fluoranthene Benzo[g,h,i]perylene Benzo[k]fluoranthene alpha-BHC beta-BHC delta-BHC gamma-BHC Bis(2-Chloroethoxy)methane Bis(2-chloroethyl) ether
SYSTEM TESTED AND CERTIFIED AGAINST ANSI/NSF STANDARD 42, 53, AND 55. Dist. by Amway of Australia, 7-9 46 Carrington Castle Hill,NSW NSW 2154 • Amway of New Zealand, Auckland Irvine Place,Rd, Bella Vista, 2153 Product Information Number: (Aust) 1800 454 647, (NZ) 0800 611 611 Manufactured by Access Business Group LLC, Ada, MI 49355 Dist.
