User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
Percentage of travelc)
Exponential rate settingd)
Assignable switch optione)
Graphic interfacef)
1. Expo Global or Separate Setting
Expo configuration for all channels can be set collectively for all
flight modes by selecting the “G-Global (globe)” symbol or you can
allow individual expo settings in each separate flight mode by
sellecting the “S-Separate” symbol.
2. Expo/Dual Rates Switch Assignment
By selecting “Switch Option” you will access the“Select Input (e)
Control” screen where you can select the control element that you
wish to control the dual rate and/or expo for the selected function.
For simple dual rates; a 2-position switch is sufficient. For more
complex triple-rates; any 3-position switch or one of the fully
proportional channels can be selected. After your selected switch
has been assigned. While the “Select Input Control” screen is still
visable you can change the switch travel by using “F2 (Prop.)”
button to select the proportional setting. The correct function can
be verified in the “Dual Rate Edit” screen by activating the switch
and observing the position number change to “Position 1-2” for a
two position switch or, if 3-position switch is used, to “Position 1-2-
3”. For a 3-position switch you will also need to use the „F1 (Centr)“
button before all three positions will be correctly displayed.
Expo/Dual Rates Travel Setting 3.
Every switch position can define a different function and (b)
exponential value. Any change made to the settings can be directly
observed on graphic interface .
(f)
Dual/Triple rate setting is defined by percentage of the travel . A (c)
higher number increases travel, a lower number decreases travel.
Expo rate is defined by percentage of the function curve Zero (d).
rate represents linear function. As expo rate increases linear travel
changes to exponential “curve” travel.
Exponential and Dual rate settings combined with flight modes
create virtually unlimited customizability.
For smooth, precise flight we highly recommend setting
up exponential and dual rates.
Advice:
4. 4.