Product Drawings

Format : [SetUP-
productID
]
Parameters :
●
productID
: A string representation of the hex value of the product ID from the manufacturer, without
the 0x prefix.
Example : [SetUP-0000]
Response : <SetUP-0000 >
72.4.1.7 Lock Configuration
Description : Locks the configuration for production use.
Format : [LkCfg-
mode
]
Parameters :
●
mode
:
●
1 = Test configuration on the next boot. The module will enumerate over USB using the configured
parameters on the next boot, then it will return to VCP mode on the following boot. This setting
may be used to verify that parameters have been set correctly. This setting does not enable
inductive charging.
●
2 = Permanently lock configuration on the next boot. This setting shall be used for all production
units.
●
All other values are reserved.
Example : [LkCfg-2]
Response : <LkCfg-2 >
72.4.2 Examples
72.4.2.1 Configure, Verify, and Lock
The following is an example factory configuration sequence which permanently locks the C162
immediately after configuration:
1.
Apply power to the C162 and connect to USB VCP interface.
2.
Issues all [Set
XX
] commands to configure the module.
3.
Verify all parameters are set to the expected values.
4.
Issue [LkCfg-2] (permanently lock firmware configuration).
5.
Cycle power, the C162 permanently boots in production mode.
2022-04-26 | Copyright © 2022 Apple Inc. All Rights Reserved.
663
72. Apple Watch Charger Module
72.4 Factory Configuration