User's Manual

Before You Begin
Caution
Notice
FCC Compliance Notice
Safety Guidelines
The following documents have been produced to help you safely operate and
make full use of your K1.
Check that you have all the included parts listed on “In the Box” 󽗉rst. Read
the entire user manual and watch the tutorial videos on the product page of
the o󽗋cial REMOVU website before you begin to use K1. If you have any ques-
tions or problems during the installation, maintenance or use of this product,
please contact REMOVU or a REMOVU distributor.
1. Intricate components inside the K1 may be damaged upon impact and
cause the gimbal to malfunction.
2. Before using the gimbal, be sure to unlock the roll motor and unlock the
pan axis lock. Otherwise, the gimbal may become damaged.
3. When storing the gimbal, be sure to lock the roll motor and pan axis lock.
Otherwise, the gimbal may become damaged.
4. The K1 is NOT water resistant. DO NOT use any liquid cleansers. Only use a
soft dry cloth to clean the K1.
5. Keep the K1 away from sand and dust to safeguard the sensors in the
camera and motors.
6. DO NOT use the K1 with Pole/Sel󽗉e Stick.
1. Hold the K1 still when it is powering up to ensure it starts up successfully.
2. Check the camera settings before start to shoot.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o󽗈
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit di󽗈erent from that to
which the receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Change or modi󽗉cations that are not expressly approved by the manufactur-
er could void the user’s authority to operate the equipment.