User's Manual

Page 13 of 30
i. Day Arm – this scenario is mostly used for child care and safety,
allowing you to monitor and protect zones while at home. For
example, monitor your medicine cabinet by simply associating the
medicine cabinet door sensor with the “day arm” scenario and
activate this scenario while at home.
ii. Night Arm – use this scenario to protect and monitor zones on
nighttime while at home. For example, protect your front door,
balcony and living room by associating the relevant door sensors
and motion detectors with the “night arm” scenario and activate
this scenario at night while at home.
b. Detection behavior when armed:
i. Always trigger alarm
ii. Allow delayed entry and exit – the alarm will not be triggered in
case of detection by the device during a predefined number of
seconds. Delayed exit gives you time to leave through the
entry/exit door without triggering the alarm. Delayed entry gives
you time to disarm the system after you enter through the
entry/exit door.
iii. Allow walking through device – when leaving an armed house,
you can walk through this device during the delayed exit time
without triggering the alarm. When entering an armed house
through a “delayed entry” door, you can walk through this device
during the delayed entry time.
c. Detection behavior when disarmed:
i. Chime - monitor pre-designated areas while the security system is
not armed. Detection of device in "CHIME" mode will produce a
tone from the siren.
5.1.2 Removing Existing Device
1. Select the device in the devices list.
2. Click “Remove Device”