User's Manual

Page 17 of 30
6.3 Mounting Window / Door Sensors
1. Each window / door sensor has 2 components: a Magnetic Detector and a
smaller Magnet. Remove one Magnetic Detector from the box.
2. Open the Magnetic Detector, using a coin or a screw driver, insert one AA
battery and then close the device. (Repeat these steps for additional Magnetic
Detectors.)
3. Use double-sided tape to mount the Magnetic Detector on the frame side of a
door or window opening. (See “A” in following diagram.)
4. Use double-sided tape to mount the Magnet on the surface of the door or window
itself, opposite the Magnetic Detector. (See “B” in following diagram.)
5. Both devices have a "•" mark on their fronts. Make sure that these "•" marks are
oriented toward each other and located at the same position and same height.
6. If required due to installation constraints, it is possible to mount the Magnetic
Detector on the surface of the door or window itself, and the Magnet on the
frame-side of a door or window opening.
7. A Green light indicates that the devices are coupled. A red light indicates that the
devices are out of range.
8. Recommendations:
 Ideal mounting locations are high up and/or difficult locations for intruders to
reach.