User Manual

Operation
54
EverGuard Control Panel
Figure 21: Dialer Configuration Dialog
2. To edit a specific parameter, mark the relevant checkbox. The parameter is
enabled. You can then modify it.
3. For SMS Configuration, GPRS Configuration and GSM DATA
Configuration set the following parameters:
 ACK Timeout –Defines the maximum amount of time (in seconds) that
the system waits to receive an acknowledge message before continuing
to the next dialing option.
 Number of Retries – Defines the number of times the dialer redials.
 Retry Timeout – Defines the number of minutes the dialer waits before
retrying.
 Min GSM Level – Defines the minimum volume level of the GSM.
4. For Cycle Permanent (minutes), set the amount of time in minutes that
the system attempts to connect using the following:
 SMS
 GSM DATA
 GPRS
5. For GSM Configuration, set the Min GSM Voice Level parameter to the
minimum volume level of the GSM voice.
6. For Video Configuration, set the parameters for the GSM Packet Delay
Time (in milliseconds).
7. Click Close. You are returned to the Control Panel screen.