User Manual

Operation
EverGuard Control Panel
61
 To configure the Dialer:
Using the Dialer Screen, set the dialing ID options
1. On the MAIN tab, click Dialer. The Dialer screen appears.
Figure 28: Dialer Screen
2. Under Phone Number, select a line item or from the Phone ID dropdown
list, select one of the thirteen dialing IDs or three video IDs to change the
information.
3. From the Comm Type dropdown list, select one of the following types:
 VIDEO
 VOICE
 MESSAGE
4. From the Comm Channel dropdown list, select one of the following:
 If VIDEO is selected, choose GSM or GPRS
 If VOICE is selected, choose GSM
 If MESSAGE is selected, choose GSM, SMS or GPRS
5. For GSM or SMS the Phone Setting is enabled. Enter the phone number that
the ID should dial.
For GPRS the GPRS Setting is enabled. Enter the IP address and port.
Figure 29: GPRS Setting
6. Click Update. The information displayed in the Phone Number section is
refreshed according to the configured settings.
7. For Dial Sequence, enter the number to which the control center is to dial