User Guide Part 3

Installation of the We.R™ System
94
We.R
™
System User Guide
3.6.3. Adding the Camera to the We.R
™
System
The Camera need to be functionally added to the system following the above described
physical installation procedure. The addition of the Camera is a standard Add Device
procedure performed as follows:
Note: You may also want to refer to paragraph 5.1 below to get acquainted
with the process of installing/ replacing a battery in the Camera.
1. Prepare the three (3) AA-size Alkaline batteries required to power the Camera.
2. Assuming the wall mounting base is already installed – release the batteries (inner) cover.
The release is done by pressing against the inner base (battery cover) tab and twist-lift of
the cover up as demonstrated in Figure 62 below:
Figure 62: Opening the Camera Inner Batteries Cover