User Guide Part 3

Installation of the We.R™ System
We.R
™
System User Guide
105
3.7.2.2. Installing with Screws
1. Release the Motion Detector wall mounting base by lifting the tab and pushing it forward as
demonstrated in Figure 70 above.
2. For Flat Wall Mounting:
i. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 71 above).
ii. Clean the surface where the Motion Detector is to be installed.
iii. Place and hold the base on the desired mounting location and mark the drilling
locations (the above-mentioned punch-outs 1 and 2).
iv. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in
the two (2) screws.
3. For Corner Mounting:
i. Repeat the above while using punch-outs 3 to 8 as required.
3.7.2.3. Installing with Pre-attached Double-side Tape
1. Release the Motion Detector wall mounting base (above Figure 70).
2. Peel the tapes’ protective covers where needed (position pending).
3. Attach the wall mounting base to its designated location while applying slight pressure.
4. Slide the Motion Detector into the wall mounting base.
3.7.2.4. Dismounting the Motion Detector
For dismounting the Motion Detector from the wall (i.e. in case of battery replacement), press
the wall mounting base's tab at the bottom of the Motion Detector and slide it downwards
simultaneously, as demonstrated in the below Figure 72.