User Guide Part 3

Installation of the We.R™ System
114
We.R
™
System User Guide
Figure 80: Releasing the Transmitter Base
Installation instructions will be divided into two parts:
 The installation of the Transmitter
 The installation of the Magnet
The mounting base, of both parts, is the Magnetic Sensor back cover (in the Transmitter unit it
also serves the purpose of battery cover).
For the Transmitter unit, the base should be disassembled from the Transmitter body, as
demonstrated in Figure 80 above, and attached to the wall either by the double-sided tape
(pre-attached to the base) or using screws as demonstrated in Figure 83 below.
3.8.2.1. Magnetic Sensor Positioning Recommendations
For optimal surveillance, the following factors must be taken into consideration when selecting
the Magnetic Sensor mounting position:
 A flat vertical window or door surface.
 Attach the Magnetic Sensor (applicable for both parts) to a surface that is clean, dry,
flat and smooth.