Use and Care Manual

Set Up and Location

1) Unpack humidifier from carton and remove all packaging material from the box.

NOTE: This unit has a natural stone tile inset. Take care when removing the

stone tile from the package, as it is breakable and heavy.

2) Lift up the chassis (upper cabinet) to locate the casters and manual.

3) Place humidifier on a flat level surface. Position the humidifier where the most

humidity is needed or where the most air will be circulated throughout the house

such as near a cold air return. If the unit is positioned close to a window,

condensation may form on the window

pane. If this occurs the unit should be

repositioned in another location.

NOTE: Due to release of cool, moist

air from humidifier, it is best to direct air

away from thermostat and hot air

registers, and to position humidifier next

to an inside wall. Unit should not be

placed where cold air from outside walls

or warm air from a hot air register blows

directly on it.

3) Place the humidifier at least 2 inches

from the wall or curtains.

Assembly

CASTERS

1) Lift chassis off of base and set aside.

2) Remove float and wick/wick retainer from base. Turn the empty base upside

down. Insert each caster stem into a caster hole on each corner of the

humidifier bottom. The casters should fit snugly and be inserted until the stem

shoulder reaches the cabinet surface.

3) Turn the base right side up.

EVAPORATIVE WICK

4) Ensure the 1043 Superwick is

installed in the two-part wick retainer

base in the base of the humidifier

5) Position the chassis over the base

frame and press it onto the base

firmly until it is in place.

6) Ensure the chassis is placed on the

base with the float facing forward.