User Guide

PAGE 6 — ESSICK EM-700S & 700P — PARTS & OPERATION MANUAL — REV. #8 (03/17/06)
RULES FOR SAFE OPERATION & SAFETY DECALS
The safety instruction decal is P/N EM948501
SAFETY INSTRUCTIONS
1. Do not operate or service this machine before reading the operating and maintenance manual.
2. Keep all inexperienced and/or unauthorized people away from equipment at all times.
3. Do not operate this equipment unless all guards and safety devices are attached and in place.
4. Keep this equipment in safe operating condition at all times.
5. Caution must be exercised while servicing this equipment.
Rotating and moving parts can cause injury if contacted.
6. Stop engine and allow to cool before adding fuel or oil.
7. Stop engine when leaving equipment.
8. Block unit when parking on a slope.
9. Unauthorized equipment modifications will void all warranties.
   Ñ    Ñ , 
■ Do not operate or service this equipment
before reading the operating and
maintenance instructions manual or serious
injury may result.
■ Do not operate this equipment unless all
guards and safety devices are attached and
in place.
■ Stop the engine when leaving the
equipment.
■ Block the unit when leaving or when using
on a slope
■ Maintain this equipment in a safe
operating condition at all times.
■ Caution must be exercised while servicing
this equipment. Rotating and moving parts
can cause injury if contacted.
■ Stop the engine before servicing, adding
fuel and oil.
■ When towing, an adequate safety chain
must be fastened to the frame, refer to page 9.
■ Keep all inexperienced and unauthorized
people away from the equipment at all times.
■ Unauthorized equipment modifications will
void all warranties.
■ Check all fasteners periodically for
tightness. Also check towing tongue bolt, lock
nut and wheel lug nuts for wear.
■ Wear safety glasses at all times when
working around machinery.
■ Stop the engine and disconnect the spark
plug before allowing anybody’s hands in the
mixing drum.
■ Never pour or spray water over the engine
or electric motor.
■ Always stand clear of dump handle when
mixer is in operation. Any binding of material
between the mixer blades and drum will cause
drum and handle to quickly move in the
discharge position.
The safety instruction decals shown must be on all Essick Mixers
Caution Decal is:
P/N EM948423
CAUTION!CAUTION!
CAUTION!CAUTION!
CAUTION!
SHUT OFF ENGINE BEFORESHUT OFF ENGINE BEFORE
SHUT OFF ENGINE BEFORESHUT OFF ENGINE BEFORE
SHUT OFF ENGINE BEFORE
PUTTING HANDS IN MIXING DRUMPUTTING HANDS IN MIXING DRUM
PUTTING HANDS IN MIXING DRUMPUTTING HANDS IN MIXING DRUM
PUTTING HANDS IN MIXING DRUM