Products, Inc. Residential Cooler Instructional Manual

ManualsBrandsEssick Air ManualsFanN30W

Date Purchased: _______________________________

Purchased From: _______________________________

P/N 70852

REV. 4/09

READ AND SAVE THIS INSTRUCTION MANUAL

OWNER’S MANUAL

WINDOW EVAPORATIVE AIR COOLER

MODEL: N30W

Summary of content (6 pages)

PAGE 1
OWNER’S MANUAL WINDOW EVAPORATIVE AIR COOLER MODEL: N30W READ AND SAVE THIS INSTRUCTION MANUAL Date Purchased: _______________________________ Purchased From: _______________________________ P/N 70852 REV.
PAGE 2
Evaporative Cooling Evaporative cooling uses the principle of evaporation to lower the air temperature. Hot, dry air is passed through wetted filters and is converted to refreshingly cooled air. Essick Coolers make the best use of the evaporative process by controlling the flow of water, spreading the water evenly over the filters, and keeping a steady stream of cooled air entering your home. It is exhausted out open windows or doors, carrying heat, smoke and odors along with it.
PAGE 3
8. Install the Side Sealer Panels. These panels are the correct height, but need to be trimmed to fit the width of our window. Trim the panels so that they reach from the window frame to the side of the duct. Slide the panels in the channels you placed on the bottom duct flange. Install the remaining Side-Sealer Channels over the top duct flange and the Side-Sealer Panels. INSTALL OVERFLOW AND DRAIN 1.
PAGE 4
MAINTENANCE 1. Once a month during cooling season, inspect your cooler for leaks, blocked water lines and excessive residue build-up on the pads. 2. At the end of the season, drain the reservoir. Remove the drainpipe and let water and dirt pass through the drain fitting. 3. Lime build-up can occur in the water reservoir and on louvers. Clean this off at least once per season.
PAGE 5
REPLACEMENT PARTS N30W Item Qty Part No. Item Qty Part No.
PAGE 6
Instructions to Convert Unit to Vertical Duct Configuration 1. 2. 3. 4. 5. Remove the 13 screws holding the Duct in place. Turn the Duct 90 degrees counter-clockwise. Align the Duct with the 3 holes provided above the blower panel. Insert 3 screws at the top and bottom of the duct. Place the Duct Mount Strip over the side Duct Flange and insert 3 screws into the holes provided. Proceed with the installation as normal. The side Sealer Channels will go on the same flanges as for a horizontal duct.