Owners manual

FCC STATEMENT AND INDUSTRY CANADA NOTICE:
1. This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Remark: This device is in accordance with the digital device grade B limitation and the
15th regulation of FCC. This limitation requires reasonable anti-interference protection
around the residence. The device can transmit radio waves during use and can interrupt
the mobile communication without proper installment. Interruption will occur for special
device. If the device does interrupt the radio or television, please turn the device off then
turn it on to adjust. Below are some resolutions for your reference:
• Move the receiving antenna
• Enlarge the distance between the device and receiver
• Try to not connect the device and the receiver on the same circuit
• Ask for professional help from experts
3. This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of Industry Canada.
Estes-Cox Corp.
1295 H Street, PO Box 227
Penrose, CO 81240-0227
Made In Shunde, Guangdong,
China
BEGINNER DRONE
• Do not turn on the Proto-Z unless controller has been turned on fi rst.
• Keep hands, hair and loose clothing away from spinning blades.
• Turn off controller and Proto-Z when not in use.
• Parental guidance is recommended.
• Do not submerge into water. This could damage electronic assemblies.
• Follow operating instructions exactly.
• Not intended for children under 8 years old.
• Replace any damaged or broken parts before attempting to fl y.
• Do not drop the Proto-Z by suddenly reducing the throttle. This could
lead to severe damage.
• The Proto-Z’s range will also be affected if the battery is not fully
charged.
• Do not touch the motors after fl ying. They can become hot.
• The battery in the Proto-Z is not replaceable.
CAUTION: Changes or modifi cations to
this product not expressly approved by
the party responsible for compliance may
void the user’s authority to operate the
equipment.
90 DAY LIMITED WARRANTY
PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE – Estes will repair or replace factory defects for 90 days from the date of purchase. This warranty
specifi cally does not cover crash damage, misuse or abuse. To make a warranty claim, please contact our product support team at 1-217-398-8970 or
e-mail us at [e-mail]
If requested by Product Support, please send defective product to: Hobby Services, 3002 N Apollo Dr., Suite #1, Champaign, IL 61822
This warranty applies only if the product is operated in compliance with the instructions and warnings provided with each model. Estes assumes no liability except for
the exclusive remedy or repair of parts as specifi ed above. Estes shall not be liable for consequential or incidental damages. Some states do not allow the exclusion
of consequential or incidental damages so the above exclusion may not apply to you. This warranty gives you specifi c legal rights and you may also have other rights
which vary from state to state.
Battery Requirements for Controller:
Requires: 2 x 1.5V AAA size batteries (not included)
Requirements for USB Charge Cord:
USB Output Jack (not included)
Battery Cautions:
• Parental guidance is recommended when installing batteries.
• Do not power controller by mixing different types of batteries, or old and new batteries.
• Use only batteries of the same or equivalent type as those recommended.
The Proto-Z is equipped with a rechargeable 3.7V LiPo battery.
Please pay attention to the following cautions for safe use:
• Do not dispose of battery into fi re or heat.
• Do not use or leave battery near a heat source, such as fi re or a heater.
• Do not strike battery or throw it against a hard surface.
• Do not pierce battery.
• Do not disassemble or alter battery.
• Turn off power switch after use.
• Recycle used batteries.
Contents
Do not touch the
spinning blades or
fl y over another person’s
head. Adult supervision is
required.
12
3
456
GET READY TO FLY
Plug the charger into a USB port
and Proto-Z as shown. (The battery
connector will only fi t in one way. Do
not force the connectors together.)
The red LED will be on when charging.
The red LED will go off once charged.
IMPORTANT!
The Proto-Z must be powered
off before charging.
Set the Proto-Z on a level surface.
Turn on the controller and then the
Proto-Z. The LED on the Proto-Z and
the controller will fl ash.
Move the left stick to
full throttle (“BEEP”),
then back to the
bottom (“BEEP”). The
Proto-Z is armed and
LEDs are solid.
Switch on controller. Make
sure left stick is down.
LED
Off
On
NEVER leave the Proto-Z unattended when
charging.
DO NOT allow the USB port to power down
when connected to the Proto-Z.
ALWAYS unplug the Proto-Z when charging
is complete.
BC
4814
™