User's Manual

1x RJ-45 ethernet port, 10/100/1000MB

1x HDMI Type A

Handle Plastic handle

Charging station 4 in 1 battery charger

Appendix B Compliance Information

B1 FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Part 15B Equipment

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturer could void the user’s

authority to operate the equipment . Modifications not expressly approved by Device Manufacturer

could void the user’s authority to operate the equipment under FCC rules.

FCC RF Radiation Exposure Statement:

 This Transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

 This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment. This device was tested for typical hand-held operations with the device contacted

directly to the human body to the sides of the de- vice. To maintain compliance with FCC RF

exposure compliance requirements, avoid direct contact to the transmitting antenna during

transmitting.